How to select right quality synthetic diamond powder for diamond tool and abrasives
Xtar Diamond Tools would like to share us with some technical issue on the diamond cutting segments as follows:
1, About the selection of Diamond Grit
When the diamond is coarse-grain and single grit, the segments is with high sharpness and high efficiency but the flexural strength will decrease. In comparison, when the diamond is fine-grain, the segments will have a longer life but with low cutting efficiency. All in all, usually we will use the grit with 50/60.
2, About the selection of Diamond strength
The diamond strength is vital for the segments cutting. If the strength is too high, the crystal is not easy to break,The abrasive grains are polished when used, it will result in cutting segments performance deterioration, on the contrary, if the strength of diamond is not enough, diamond is easy to crack and cannot have a good cutting performance. So the strength should be at 130 to 140N.
With good command of cuting segments technology, Xtar diamond tools is able to deal with any technical issue and appreciate your willingness in sharing with us any technical matters.